Tapered roller bearing temperature, generally bearing chamber outside temperature can be inferred that if the hole can be measured directly using the bearing outer ring temperature is more suitable position. Today, I told you about SKF bearing temperature check on little knowledge.
Typically, SKF Bearings with bearing operating temperature slowly began to rise 1-2 hours to reach steady state. The normal temperature because of the machine bearing the heat capacity, heat capacity, speed and load are different. If lubrication, install the appropriate department, the abrupt bearing temperature will rise, there will be an abnormally high temperature, time to stop running, take the necessary precautions.
Thermal sensors can be readily monitored using the bearing operating temperature, and the temperature exceeds the specified value to achieve automatic alarm or stop to prevent burning shaft accidents.
SKF bearings with high temperature often expressed in unusual circumstances. Temperature is harmful to the bearing lubricant. Sometimes bearing overheating can be attributed to the bearing lubricant. If the bearing temperature over 125 �� even move to reduce long bearing life. Caused by high bearing the following reasons: lack of lubrication or excessive lubrication, lubricant. Containing impurities, the load is too large, the bearing ring damage, lack of space, and produce high-friction seals and so on.
Therefore, continuous monitoring of bearing temperature is necessary, whether it is measuring the bearing itself, or other important parts. If the operating conditions remain unchanged in the case of temperature change can be said of any fault has occurred.
SKF bearing temperature measurement by means of a regular thermometer, digital thermometer such as bearings, bearing temperature can be accurately measured and determined in accordance �� or Fahrenheit units.
The importance of SKF bearing, which means when it is damaged, can cause equipment downtime, so this type of bearing temperature probe should preferably be installed.
Under normal circumstances, tapered roller bearings in the recently re-lubrication or lubrication after the temperature rise will be natural and lasts one to two days.